after using this system for a week my PH is now 7.0 - how do I get it back to normal range? I adjusted the infusion setting from 120 to 100 but it didn;t change the PH - and I have no idea how to change the ""flow Rate"" the instructions don;t tell how to do that. CircuPool TOTALBalance pH Control System with Patented CO2 Infusion | Acid-Free pH Control

Question

after using this system for a week my PH is now 7.0 - how do I get it back to normal range? I adjusted the infusion setting from 120 to 100 but it didn;t change the PH - and I have no idea how to change the ""flow Rate"" the instructions don;t tell how to do that. CircuPool TOTALBalance pH Control System with Patented CO2 Infusion | Acid-Free pH Control

Status: Open Nov 26, 2020 - 04:00 PM

Do you have the same question? Follow this Question

1answer

Voted Best Answer

Nov 29, 2020 - 04:00 PM

According to the manual, the Flow Adjustment xxxx is the dial that is on the lower left of the unit. Turning down the flow rate on the unit will supply less CO2 to the water, meaning that it ""won't be working as hard"" to lower the pH. For any pool equipment, a good rule of thumb is to make small adjustments, and then check the water in 24-48 hours to measure the result. A good pH range is typically 7.2-7.8.