About This Q&A
Ask a question and receive knowledgeable answers from topic experts
Asked 5 ´months ago
Asked 6 ´months ago | Replacement Salt Cells
Asked 6 ´months ago | Salt Chlorinators > CircuPool EDGE-25 Salt Chlorine Generator
Asked 7 ´months ago
Do you need to run your pool pump more if you switch to salt View answer
Asked 1 ´year ago
Ate these good for above ground pools? View answer
Asked 1 ´year ago
Price for replacement cell for Circupool EDGE 25? View answer
Asked 1 ´year ago | Parts / Accessories
Suppose that the average air temperature in winter is 56 F and the pool sits at 56 F. On the smallest unit, how much power (or current at 208 V) would be required to raise a 20,000 pool to 75F? With solar blanks on the surface, how much power would be needed then to maintain it at 75 F? Then in the summer, the average temperature is 78 F but we want it to be 82 F. How much power would be required to maintain it at 82? View answer
Asked 1 ´year ago | Temperature Control > PAL Pool Touch Evenheat 65,000 BTU Heater + Chiller | Full Inverter Heat Pump | Variable-Speed Compressor For Extreme Energy Savings
Hi -- How many Amps does this Salt Chlorinator pull at start up and after start up on a 220v connection. I want to know if both the Pool pump, Compressor and Chlorinator can be tied to the one 220v outlet View answer
Asked 5 ´years ago | Salt Chlorinators > CMP Powerclean Salt Ultra 540 Salt Chlorinator (SGS Saline Generating Systems Breeze 540) | 52000-240-000
is this a direct fit as far as the size of the unit View answer
Asked 8 ´months ago
how much salt to add to the pool for the first time View answer
Asked 6 ´months ago
I see that the ic20 aftermarket replacement does more. My only worry is that it will run constantly. does the flow switch stop the salt generation when the pump is off? If so, I see no reason for the communication cable anyway. Is there any reason not to replace pentair with aftermarket? View answer
Asked 3 ´years ago | Salt Cells > APX PERFORMANCE P20 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC20® Cells | up to 20,000 gallons
are the rj-30 and cpsc 24 cells interchangeable ? View answer
Asked 5 ´months ago
I have a circupool Si series with a Si30 cell. System keeps saying salt is low, reading 2400, but test at pool store says in range. I have cleaned cell, and no change in reading. Setting is set at cell type F-15. Is this the correct setting? Any ideas on what I need to do? Thank you. View answer
Asked 4 ´years ago | CircuPool® Si-15 Replacement Cell
I have a 40000 gallon pool with a hayward aquarite goldline plus system. My old cell kept giving a low salt reading so i put in more salt several times but it did not change. I ordered your replacement cell and the diagnostics said 6400 ppm salt level. I drained maybe 15,000 gallons and refilled it and the salt reading in diagnostics is still 6400 ppm. Any suggestions? View answer
Asked 2 ´years ago | Salt Cells > CircuPool® GEN15 Aftermarket Replacement Cell fits Hayward® AquaRite® 40,000 Gal. Models
The status light on my Breeze Chlorinator board is flashing green. What does this indicate? Note: i just purchased a replacement cell from you and installed it.thanks View answer
Asked 6 ´years ago | Salt Cells > Saline Generating Systems SGS Breeze 320 Replacement Salt Cell (now CMP Powerclean Salt Ultra)
What is the best salt level for the sj20 View answer
Asked 3 ´years ago | Salt Chlorinators > CircuPool SJ-20 Salt Chlorine Generator
Circupool Salt clorinator- the light flashing says generate View answer
Asked 4 ´months ago | Salt Cells > CircuPool® Si-30 Replacement Salt Cell
<!--IT says you can upgrade from edge 25 to edge 40 for a dollar. -->My question is are both edge 25 & 40 compatible with each other so when the cell goes, I can replace the cell with the edge 25 or do I have to stay with the edge 40 View answer
Asked 4 ´years ago | Salt Chlorinators > CircuPool EDGE-25 Salt Chlorine Generator
Ask a question and receive knowledgeable answers from topic experts