Question 1

I’m new to salt water pools and the circupool which we installed this summer. We leave our pool running all winter even though it is cold. What do we need to do for circupool part? Shut off? Leave it in running, etc? And if running, what setting should it go on? View answer

Asked 4 ´years ago | Salt Chlorinators > CircuPool CORE-55 Salt Chlorine Generator

Question 2

Do I need to empty the chlorine water that I have now in order to switch to sal water? View answer

Asked 15 ´days ago

Question 3

Do salt water pools cause rust around the pool View answer

Asked 3 ´months ago

Question 4

How effective is a salt cell with 80% of its life used View answer

Asked 7 ´months ago | Salt Cells

Question 5

does the unit come with both 2"" and 1 1/2 couplings View answer

Asked 2 ´years ago | Filters > CircuPool TJ-16 "Typhoon" Centrifugal Pre-Filter

Question 6

I have a variable speed pump that controls all the timing onboard and the pump shuts off at night. If I directly wire this unit to a breaker can I just use the flow valve to control the chlorinator? The wiring instructions show it being wired to a timer, which I don't have in my system. View answer

Asked 5 ´years ago | Salt Chlorinators > CircuPool RJ-45 PLUS Salt Chlorine Generator

Question 7

can I adjust the temp and salt readings on the unit View answer

Asked 5 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 8

When would it be shipped, if I place an order now? View answer

Asked 4 ´years ago | Salt Cells > Optimum® Simple Cell for T15 Replacement cell fits Hayward® Aqua Rite® T-CELL-15® | up to 40,000 gallons

Question 9

I have 16.5 inches of pipe above my pump. Is that enough? View answer

Asked 1 ´month ago

Question 10

The flow switch has failed on my IC 40 before. Can the flow switch be replaced on this unit, and do you carry the part? View answer

Asked 5 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 11

For the pump CircuPool SmartFlo® Variable Speed Pool Pump 1.5, if it does not use the old mechanical timer, how do you control the attached cleaner booster pump. It is currently wired where the pump must be on for it to be on. View answer

Asked 2 ´years ago | Manufacturers > CircuPool > CircuPool SmartFlo® Variable Speed Pool Pump - 1.7 THP

Question 12

Can you provide a performance chart ( flow g/m, rpm and watts) for this model? What is it's maximum gal/m? Thank you View answer

Asked 2 ´years ago | Manufacturers > CircuPool > CircuPool SmartFlo® Variable Speed Pool Pump - 1.7 THP

Question 13

Aqua-Rite Firmware requirements View answer

Asked 1 ´month ago

Question 14

Who provides the warranty service on this item? If I buy it and need warranty service do I go through the manufacturer or through DSP.com? View answer

Asked 6 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 15

how many devices can I connect to this ? View answer

Asked 1 ´year ago

Question 16

Do you sell the control center cover by itself? Mine cracked because of the sun, the system is working fine, but the cover fell off due to being broken. View answer

Asked 4 ´years ago | Salt Chlorinators > CMP Powerclean Salt Ultra 760 Salt Chlorinator (SGS Saline Generating Systems Breeze 760) | 52000-260-000

Question 17

Can you use an RJ45+ cell on an RJ30+ system View answer

Asked 2 ´months ago | For Medium Pools

Question 18

Can your Pentair IC40 replacement cell be installed vertically? Is there an advantage or disadvantage to doing so? View answer

Asked 1 ´year ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 19

Hello.How can I have the LCD display backlight be on all the time ? It would be convenient to see it at a glance insted of having to go over to it and press the button View answer

Asked 2 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 20

To clean plates, do you remove top section panel each time View answer

Asked 1 ´month ago

Question 21

Can I plug into a 110 outlet or do I have to hardwire it into the timer that cuts my pump on and off? View answer

Asked 5 ´years ago | Salt Chlorinators > CircuPool Universal40 Salt Chlorine Generator

Question 22

Does this still create ozone, even if the water does not have chlorine/salt in it? View answer

Asked 3 ´years ago | Ozone > CircuPool INDIGO3-XL Ozone Generator for Swimming Pools

Question 23

Does the SJ40 have a built in timer? View answer

Asked 9 ´years ago | Salt Chlorinators > CircuPool SJ-45 Salt Chlorine Generator

Question 24

I'm getting ready to install a Circupool TJ-16 Typhoon that I purchased from you folks' last fall. My question is, can this be installed outdoors in direct sunlight and not have adverse effects on the clear plastic housing? View answer

Asked 1 ´year ago | Filters > CircuPool TJ-16 "Typhoon" Centrifugal Pre-Filter

Question 25

I am going to use this salt cell to replace my Ichlor 30. Will this come with an install template?? View answer

Asked 12 ´months ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 26

Can i use it with a variable speed pump? What would be the mínimum RPMs for the pump in order to generate chlorine? View answer

Asked 4 ´years ago | Salt Chlorinators > CircuPool SJ-35 Salt Chlorine Generator

Question 27

I am unsure of the Breeze model I have, so I asked my pool guy how many gallons my pool is, he thinks it's 20,000 gallons but unsure. I am thinking that the unit is the Breeze 320, but your replacement shows to have 3 blades, mine has 5, would this likely be a different model than the 320? View answer

Asked 1 ´year ago | Salt Cells > APX PERFORMANCE S3 Aftermarket Replacement Cell fits Saline Generating Systems® Breeze® 320 (now CMP® PowerClean Salt®)

Question 28

I just installed the Core 35, my biggest concern is rain, i assume its water proof and it does have a lot of sun hitting it, can i cover it? or does it need airflow for cooling. View answer

Asked 3 ´years ago | Salt Chlorinators > CircuPool CORE-15 Salt Chlorine Generator

Question 29

I am looking. For the power cord for the T-9 cell for Hayward Aqua Rite salt pool systems made by CircuPool. View answer

Asked 6 ´years ago | Salt Cells > CircuPool® CIR-GEN9 Aftermarket Replacement Cell fits Hayward® AquaRite® 25,000 Gal. Models

Question 30

I have a circupool Si series with a Si30 cell. System keeps saying salt is low, reading 2400, but test at pool store says in range. I have cleaned cell, and no change in reading. Setting is set at cell type F-15. Is this the correct setting? Any ideas on what I need to do? Thank you. View answer

Asked 3 ´years ago | CircuPool® Si-15 Replacement Cell

Question 31

The status light on my Breeze Chlorinator board is flashing green. What does this indicate? Note: i just purchased a replacement cell from you and installed it.thanks View answer

Asked 5 ´years ago | Salt Cells > Saline Generating Systems SGS Breeze 320 Replacement Salt Cell (now CMP Powerclean Salt Ultra)

Question 32

What is good to add to a salt pool to keep liner from fading and last longer? View answer

Asked 1 ´month ago

Question 33

Will it fit my 11 inches pure Chlor system? View answer

Asked 1 ´month ago

Question 34

I have a variable speed pump. I know this has a flow switch. Am I able to leave power on to the unit 24/7 and when the pump turns on, the chlorinator will work and when the pump is off, it will "shut off" and not cause damage? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool SJ-20 Salt Chlorine Generator

Question 35

What is the best salt level for the sj20 View answer

Asked 2 ´years ago | Salt Chlorinators > CircuPool SJ-20 Salt Chlorine Generator

Question 36

No acid is necessary for cleaning the cell... so how is it cleaned? View answer

Asked 3 ´years ago | Salt Chlorinators > CircuPool SJ-20 Salt Chlorine Generator

Question 37

Has anybody used the CircuPool salt-cell for a long period? Do they last? Any experience with warranty support? I purchased a CompuPool salt cell once which had a 3-year warranty. The cell failed in a year and support was nonexistent View answer

Asked 6 ´years ago | Salt Cells > CircuPool® GEN15 Aftermarket Replacement Cell fits Hayward® AquaRite® 40,000 Gal. Models

Question 38

the cell I want to replace says turbo cell T-cell -15 turbulent flo chamber electrolytic cell for 20,000 gallon in-ground pool View answer

Asked 6 ´years ago | Salt Cells > CircuPool® GEN15 Aftermarket Replacement Cell fits Hayward® AquaRite® 40,000 Gal. Models

Question 39

I have a handrail that is anchored to pool floor next to shallow end steps that my current cleaner gets stuck in because it doesn’t back up far enough. Will this cleaner back up and go around this area without getting stuck? View answer

Asked 2 ´years ago | Robotic Cleaners > Beatbot A100 Pro - Cordless Robotic Cleaner & Skimmer For In-Ground Pools | Advanced Pool Navigation with Wifi

Question 40

I currently have a Breeze 540 and I need to replace the cell. Can I upgrade the Cell to a 760 without changing the rest of the system? View answer

Asked 6 ´years ago | Breeze > Saline Generating Systems SGS Breeze 540 Replacement Salt Cell (now CMP Powerclean Salt Ultra)

Question 41

I have a 40000 gallon pool with a hayward aquarite goldline plus system. My old cell kept giving a low salt reading so i put in more salt several times but it did not change. I ordered your replacement cell and the diagnostics said 6400 ppm salt level. I drained maybe 15,000 gallons and refilled it and the salt reading in diagnostics is still 6400 ppm. Any suggestions? View answer

Asked 2 ´years ago | Salt Cells > CircuPool® GEN15 Aftermarket Replacement Cell fits Hayward® AquaRite® 40,000 Gal. Models

Question 42

Replacement cell ??? Price View answer

Asked 11 ´months ago | For Small Pools > Saltron Retro Chlorine Generator For Above Ground Pools | SOLAXX | Plug-In Model

Question 43

my current set up is for an intellichlor Model IC40. Will this fit in where the old salt cell used to be? View answer

Asked 5 ´years ago | Salt Chlorinators > CircuPool CORE-35 Salt Chlorine Generator

Question 44

I have Hayward aqua rite goldline with 940 cell T-15, will Circupool GEN15+ work. View answer

Asked 8 ´months ago | Salt Cells > CircuPool® CircuPool GEN15+ Aftermarket Replacement Cell | 4-yr Warranty | Premium Clear Cell

Question 45

Can this unit be converted to 110V? How long do the cells last? How much do replacement cells cost? View answer

Asked 7 ´years ago | Salt Chlorinators > CircuPool SJ-20 Salt Chlorine Generator

Question 46

Do you sell the replacement cells for this? I am wondering how much they cost. View answer

Asked 3 ´years ago | Salt Chlorinators > CircuPool CORE-35 Salt Chlorine Generator

Question 47

What exactly is the super chlorination mode on the p20 ? And is it necessary at installation if the chlorine level in the pool is already between 1.0 and 4.0 ppm ? View answer

Asked 2 ´years ago | Salt Cells > APX PERFORMANCE P20 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC20® Cells | up to 20,000 gallons

Question 48

I have a Hayward Goldline TurboCell T-Cell-9. Will this Optimum T15 cell be compatible with my current cell? View answer

Asked 1 ´year ago | Salt Cells > Optimum® Simple Cell for T15 Replacement cell fits Hayward® Aqua Rite® T-CELL-15® | up to 40,000 gallons

Question 49

My PVC runs horizontal, and have pipe running parallel, under the section where I need to install this, which doesn’t leave me with enough clearance needed for the bottom of the cell. Can I pivot this when installing so the controls are back at an angle, and the bottom of the cell is more towards the front, to get around the PVC below? Or does this need to be installed straight up and down as shown? View answer

Asked 11 ´months ago | Salt Chlorinators > E-CHLOR Plug-In Electronic Chlorine Generator | APX PERFORMANCE | For Pools up to 32,000 Gallons

Question 50

I have a 16,000 gallon inground gunite pool, with heater, Ultra UV2 light, inline tablet chlorinator and want to switch to a SWG. Can I install a RJ-60+ or is that too big? Do I need to remove the Ultra UV2 light and inline tablet chlorinator? Also, my CYA level are extremely high, do I need to get those down before converting? View answer

Asked 2 ´years ago | Salt Chlorinators > CircuPool RJ-60 PLUS Salt Chlorine Generator

Browse by Topic

Tools