Question 1

Will this be okay for 10k gallon pool with filter cartridge or do i need a sand filter as well?? View answer

Asked 3 ´years ago | Salt Chlorinators > CircuPool Universal40 Salt Chlorine Generator

Question 2

Is this system large enough for a 15k gallon pool or is it better to upgrade?Does it come with instructions?Is it recommended to wire the salt cell yo run with the pump?Thanks! View answer

Asked 6 ´years ago | Salt Chlorinators > CircuPool SJ-20 Salt Chlorine Generator

Question 3

CMP Powerclean Salt Ultra 540 View answer

Asked 3 ´months ago

Question 4

Is the SJ-20 Series run on 110Volts? View answer

Asked 6 ´years ago | Salt Chlorinators > CircuPool SJ-35 Salt Chlorine Generator

Question 5

Where do I buy the salt for a 8500 gallon pool View answer

Asked 7 ´months ago | pH Controls

Question 6

Can I change this t-9 for the t-5 I have? Blue essence is the Hayward I have View answer

Asked 9 ´years ago | Salt Cells > CircuPool® CIR-GEN9 Aftermarket Replacement Cell fits Hayward® AquaRite® 25,000 Gal. Models

Question 7

Can it filter sand and fine dust View answer

Asked 7 ´months ago

Question 8

I have a blue essence t-9 20,000 gallon salt cell, can I replace it with your aqua-rite t-9 25,000 gallon salt cell? View answer

Asked 9 ´years ago | Salt Cells > CircuPool® CIR-GEN9 Aftermarket Replacement Cell fits Hayward® AquaRite® 25,000 Gal. Models

Question 9

Power and polarity lights are lit. Salt level is good by independent analysis and water flow is good. No Flow light stays lit and therefore cell will not generate chlorine. Is the flow sensor/switch integral to the replacement cell or is it a different assembly? View answer

Asked 9 ´years ago | Salt Cells > APX PERFORMANCE C7 Aftermarket Replacement Cell fits CompuPool CPSC-36 | up to 36,000 gallons

Question 10

Replacement chord for digital nano model#75041A View answer

Asked 7 ´months ago | Replacement Salt Cells

Question 11

If I calculated my pool at 14K gal, why do you think they installed a Haywood T-15 and not a T-9? View answer

Asked 9 ´years ago | Salt Cells > CircuPool® CIR-GEN9 Aftermarket Replacement Cell fits Hayward® AquaRite® 25,000 Gal. Models

Question 12

Can this control unit be exposed to the elements? View answer

Asked 7 ´years ago | Salt Chlorinators > CircuPool RJ-30 PLUS Salt Chlorine Generator

Question 13

My rj45 controller touch pad is not working other than the power and super clor buttons. Will this correct the issue the system is 5 years old. View answer

Asked 3 ´years ago | RJ Keypad (3rd Gen, RJNK, 11-11 Pin)

Question 14

What is the flow at which this turns on and off? Setting up my variable speed pump. How many hours a day should this run and day or night? View answer

Asked 2 ´years ago | Salt Chlorinators > CircuPool Universal25 Salt Chlorine Generator

Question 15

Are these systems ok to use in above ground pools? View answer

Asked 2 ´years ago | Salt Chlorinators > CircuPool EDGE-15 Salt Chlorine Generator

Question 16

Will this work on my blueworks BLH20 A Y ? View answer

Asked 7 ´months ago

Question 17

Is this the complete kit ? Aka everything I need for setup ? I don’t want to purchase and find out I need to spend more View answer

Asked 4 ´years ago | Salt Chlorinators > CircuPool Universal25 Salt Chlorine Generator

Question 18

Can this be used to replace a Pentair IC30 and still use the existing power cell? View answer

Asked 4 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 19

I have an inground pool that is approximately 17k gallons and would like to know if the SJ35 would be a good choice for a replacement chlorine generator. I currently have a Breeze 320 that is not working and noticed that the SJ35 is similar in appearance and installation. View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool SJ-35 Salt Chlorine Generator

Question 20

Is this compatible with AQRS340 for a Hayward Aquarite S3 unit? View answer

Asked 4 ´years ago | Parts > Bypass Cell (fits Hayward® Aquarite®, Swimpure Plus®, CircuPool RJ, CircuPool Si)

Question 21

I currently have a pentair IC40. I’m leaning strongly toward getting a APX cell to replace the pentair one with. I’m thinking of stepping up to the 60,000 gal model APX60. Will the APX 60 fit right into the existing piping that my ic40 is mounted. Or does it require modification to allow the apx60 to fit?? View answer

Asked 1 ´year ago | P-Series Inner Cells > APX PERFORMANCE P-Series Inner Replacement Cell for the P60 (Housing and Electrode Only)

Question 22

What does the yellow light mean on an SJ55 salt system? View answer

Asked 6 ´years ago | Salt Chlorinators > CircuPool SJ-55 Salt Chlorine Generator

Question 23

Why do you think your generic unit is better than the Pentair ic40?tks View answer

Asked 6 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 24

I have the following setup VSP Pentair 1.5 hp 1-1/2"" pipes SWG: CircuPool RJ+60 Gallons 43,000 To run pump 24/7 will need to run at 30-35 gpm to properly filter the water over night. Will SWG work at this rate? View answer

Asked 1 ´year ago | Salt Chlorinators > CircuPool RJ-60 PLUS Salt Chlorine Generator

Question 25

Does the 24 model work in place of the 16 model View answer

Asked 6 ´years ago | Salt Cells > APX PERFORMANCE C4 Aftermarket Replacement Cell fits CompuPool CPSC-16 | up to 16,000 gallons

Question 26

Bought the 25 about 2 years ago and I love it. Best thing I ever did for the pool. Today for the first time the generating light is blinking and the screen says HOT. What does that mean it's in the70s during the day and in the 40s during the night. What is hot? It can't be the water temp. Please advise...........wally View answer

Asked 2 ´years ago | Salt Chlorinators > CircuPool Universal25 Salt Chlorine Generator

Question 27

I have an above ground pool, my current pump has a regular plug but according to the SJ-35A system, they both have to be hard wired into a timer. Can I not purchase a plug for the SJ-35A to plug into a timer or do I have to have my pump cord changed? View answer

Asked 2 ´years ago | Salt Chlorinators > CircuPool SJ-35 Salt Chlorine Generator

Question 28

What is the width of the control panel once it’s installed on the pipe?

Asked 7 ´months ago

Question 29

My cell Has 35/22 on it. Is this the cell that I need? View answer

Asked 9 ´years ago | Salt Cells > Autopilot PPC1 Replacement Salt Cell (for RC-35/22, SC-36 cells)

Question 30

Does it mater what direction the water flow is across the elements View answer

Asked 5 ´years ago | Salt Chlorinators > CircuPool RJ-30 PLUS Salt Chlorine Generator

Question 31

"Generate" not lit View answer

Asked 6 ´months ago

Question 32

what are the filter clamps and clamp knobs? The start up directions say to "Properly seat filter clamps and securely tighten clamp knobs before proceeding". View answer

Asked 7 ´years ago | Filters > CJ-150 Cartridge Filter

Question 33

Does this unit come with a flow sensor? Is this a complete system? View answer

Asked 6 ´years ago | Salt Chlorinators > CircuPool Universal40 Salt Chlorine Generator

Question 34

I live in sW florida. Have a 13,000 gallon in ground pool using chlorine which I want to change to salt. Is the RJ 30 the best choice for me? View answer

Asked 8 ´years ago | Salt Chlorinators > CircuPool RJ-30 PLUS Salt Chlorine Generator

Question 35

My pool is closer to 70,000. Can the controller piggy back the cell and have 2 in series? View answer

Asked 5 ´years ago | Salt Chlorinators > CircuPool RJ-30 PLUS Salt Chlorine Generator

Question 36

I have a PureChlor salt cell for my 22,000 gallon pool. What size of unit do you recommend?What part number to I need? View answer

Asked 3 ´years ago | Salt Cells > Resilience A5 / D5 Replacement Salt Cell (also fits Nexa Pure/Ipure/Frog Hybrid)

Question 37

How do I know what size my CircuPool SJ-Classic Series is? Our pool is 27,000 gallons. View answer

Asked 1 ´year ago | Salt Cells > CircuPool® SJ-55 Classic Replacement Salt Cell

Question 38

My Pentair Intellichlor salt chlorine generator model 40 is not working I have spent over $500 in chemicals the last month it’s not producing it’s chlorine but I do not know the difference between a cell and a generator which one do I need the generator or the cell? Are they the same? Thank you for your help. View answer

Asked 1 ´year ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons

Question 39

Is this over kill for a oval 18 x 33 48 inch pool out in direct sun light in south east texas View answer

Asked 4 ´years ago | Packages > Classic Combo (Large Pools) - (RJ-45 PLUS Salt System + SmartFlo® VS Pump - 3.0 THP)

Question 40

I am adding a salt water system to a 40000 gal pool, when I do a liner change. Is this all I need? View answer

Asked 7 ´years ago | Salt Chlorinators > CircuPool Universal40 Salt Chlorine Generator

Question 41

Compatible replacement for the Hayward swimpure extreme tcell925 swp

Asked 6 ´months ago | Parts / Accessories

Question 42

Can the complete RJ-45 Plus System replace my current complete Si+ 45 System (Control Panel, Flow Sensor, Cell) WITHOUT cutting, gluing, retrofit any electrical connections, require professional installation? In other words, will the RJ-45 Plus Complete System be an easy Plug and Play to my existing system? View answer

Asked 3 ´years ago | Salt Chlorinators > CircuPool RJ-45 PLUS Salt Chlorine Generator

Question 43

Will any of these salt systems hook to any pump? View answer

Asked 5 ´years ago | Salt Chlorinators > AutoPilot Pool Pilot® Evolve + PPM1 Manifold for 30,000 gallon pools

Question 44

Our pool is 18×37.5 .So is salt ok on liner?Can you replace our liner as well as convertt to salt.wha t is cost involved? View answer

Asked 6 ´years ago | Salt Chlorinators > CircuPool EDGE-15 Salt Chlorine Generator

Question 45

We have a variable speed pump, does the pump have to be at a certain gallons per minute for this to work correctly? View answer

Asked 1 ´year ago | Filters > CircuPool TJ-16 "Typhoon" Centrifugal Pre-Filter

Question 46

Will this work on my SJ series Generator? View answer

Asked 5 ´years ago | Parts > CircuPool SJ - Hayward®/Pentair® Cell Adapter Kit

Question 47

how do i replace the fuse in a circu pool rj control ? View answer

Asked 9 ´years ago | Parts > 5-Amp Fuse Reset Button (CircuPool RJ-Classic Models Only)

Question 48

What are the measurements of the control module? View answer

Asked 4 ´years ago | Salt Chlorinators > CircuPool RJ-45 PLUS Salt Chlorine Generator

Question 49

can you use salt generator with a ultraviolet light system ? View answer

Asked 8 ´years ago | Salt Chlorinators > CircuPool RJ-45 PLUS Salt Chlorine Generator

Question 50

When I was reading the installation instructions for the RJ45 plus, it states if using with a variable speed pump (on a low speed setting) that the cell must be inverted. If I'm installing the RJ45 plus vertically, does that mean I can't use the low speed on my variable speed pump? View answer

Asked 3 ´years ago | Salt Chlorinators > CircuPool RJ-45 PLUS Salt Chlorine Generator

Browse by Topic

Tools