What are the measurements of the control module? View answer
Asked 4 ´years ago
How many hours do I need to run the pump to get the 2lb of chlorine? View answer
Asked 8 ´years ago
Can the flow switch with the RJ45+ system be installed in a vertical position following a 90 degree elbow after where the cell is installed (horizontally)? This is the portion of the pipe before that is still visible before it goes underground to return water to the pool (i.e. the last point before water returns to the pool). View answer
Asked 4 ´years ago
How do you estimate Pool Capacity of a kidney shaped pool? View answer
Asked 8 ´years ago
How many amps does the RJ 45 pull in a 220v setup? View answer
Asked 4 ´years ago
I see in an earlier question, someone asked about the voltage requirements for the unit. I see that the answer was based on 110V or 220V (which I assume is Split phase). My area (north east usa) is primarily 120V -240 V split phase. Is this going to be an issue with your unit? Do i have to cap my Voltage with a transformer? View answer
Asked 5 ´years ago
I have a Compupool Titanium 60K salt generator that seems to have died. Displays only software version. Will not reboot. Salt Pro direct has not replied. Warranty still in effect. Is customer service and reliability any better? Have gone through 4 cells in 4 years, but still a PIA. View answer
Asked 6 ´years ago
can you use salt generator with a ultraviolet light system ? View answer
Asked 7 ´years ago
