CircuPool RJ-60 PLUS Salt Chlorine Generator Q&A

Question 1

what is the difference between SJ & the RJ systems? View answer

Question updated 3 months ago

Question 2

I have a circupool RJ60+. Is there a way to modify the length of time between self cleaning cycles? View answer

Asked 8 ´months ago

Question 3

Which, if any, Circupool Salt water generators support RS – 485 communication? View answer

Answer posted 8 months ago

Question 4

Is there anyway I can buy the cell for an RJ-60+? View answer

Answer posted 9 months ago

Question 5

What type of plug does it come with?? View answer

Answer posted 11 months ago

Question 6

I have the following setup VSP Pentair 1.5 hp 1-1/2"" pipes SWG: CircuPool RJ+60 Gallons 43,000 To run pump 24/7 will need to run at 30-35 gpm to properly filter the water over night. Will SWG work at this rate? View answer

Answer posted 1 year ago

Question 7

my return pipe is on a 45° angle, can this be installed on the gangle or does in need to be either vertical or horizontal? View answer

Answer posted 1 year ago

Question 8

Does the RJ60 plus include WiFi control? View answer

Answer posted 1 year ago

Question 9

Is the rated lifespan of the cell determined when running at 100%? So if the lifespan is 15k hours, is it safe to assume we could get closer to 30k hours running at 50%? Just trying to ballpark what to expect. View answer

Answer posted 2 years ago

Question 10

I have a 16,000 gallon inground gunite pool, with heater, Ultra UV2 light, inline tablet chlorinator and want to switch to a SWG. Can I install a RJ-60+ or is that too big? Do I need to remove the Ultra UV2 light and inline tablet chlorinator? Also, my CYA level are extremely high, do I need to get those down before converting? View answer

Answer posted 2 years ago

Question 11

I currently have a Hayward Agua Logic system that controls the chlorinated as well as the pool lights, a Polaris cleaner, and a heater….will the RJ+ control all of these systems? View answer

Answer posted 2 years ago

Question 12

Good morning from Alabama. Currently I have an Aqua Rite chlorinator system with a T-15 cell. I am looking to purchase a new RJ-45 system to replace my lightening destroyed system. My power source is 230 volt and I am wonder if this will work with the RJ-45. Also. is the RJ-45 over kill for my pool also? I like over kill as my pool is in direct sunlight all day during the summer. Thank you and I am glad I found your website. View answer

Answer posted 2 years ago

Question 13

Looking at the the RJ 60 salt system, my pool is an 18x36 around 36000 gal. Is the system an over kill or will run less often? View answer

Answer posted 3 years ago

Question 14

Want is the difference between a RJ and anRJ + system ? Thanks View answer

Answer posted 3 years ago

Question 15

Is your top of the line system self cleaning? View answer

Answer posted 3 years ago

Question 16

I bought an rj60 in 2018 and isn’t working, my pool guy wants me to replace it, what should I do View answer

Answer posted 3 years ago

Question 17

Is the cell a direct replacement for a hayward? Can I buy just the cell and reuse my hayward controller? View answer

Answer posted 3 years ago

Question 18

How hard is it to install this salt water generator? Also, we have a 50,000 gallon pool that is used frequently in hot Texas. Will this generator be big enough? Thank you! View answer

Answer posted 4 years ago

Question 19

Water Pump is Pentair and pool is 30m gallons, best choice? View answer

Answer posted 4 years ago

Question 20

Can this be powered by solar? We have a solar pool pump and would like the whole system to be off grid. View answer

Answer posted 4 years ago

Question 21

Can I replace a RJ-45 cell with a RJ -60 cell and not replace the other parts. View answer

Answer posted 4 years ago

Question 22

Does the RJ60 controller need to be protected from weather or can it be hung on the side of the house next to the pump and filter? View answer

Answer posted 4 years ago

Question 23

I see that the cord for the main unit is 14 feet - is the cord for the flow sensor the same length? View answer

Answer posted 4 years ago

Question 24

is the controls box water proof or does it have to be enclosed. View answer

Answer posted 5 years ago

Question 25

I plan to mount my new RJ-60 PLUS to a brick wall. Does the package come with screws and anchors to mount it to a brick wall? If not what do I need to buy to mount it to a brick wall? Thank you! View answer

Answer posted 5 years ago

Question 26

How do you clean the cell? View answer

Answer posted 5 years ago

Question 27

Can I switch my chlorine pool to a salt system without effecting the current pool heater? View answer

Answer posted 5 years ago

Question 28

How long is the cable from the cell to the controller and do you sell extensions? View answer

Answer posted 5 years ago

Question 29

In what increments can you adjust the chlorine generation of the CircuPool RJ-60 PLUS ? In other words, each time you depress the ""+"" for greater prodution of chlorine, in what increment does the value of production increase? View answer

Answer posted 5 years ago

Question 30

How do you clean the salt cell? Do you need acid? View answer

Answer posted 5 years ago

Question 31

Is using 110 V with plug in to receptacle as good as 220 V hard wired? Does vertical installation of cell as good a horizontal? View answer

Answer posted 5 years ago

Question 32

I have an old (and broken) Zodiac LM3-24 salt water generator installed on my pool. The previous owners of the house installed it and didn't maintain it very well, and the entire system is now in need of replacement. I am looking for a new system that I can fit into the existing space that the LM3-24 is currently occupying, without having to cut or drill anything. Will the CircuPool RJ-45 or -60 be a direct replacement for the LM3-24 that I have or will it require some extra cutting? I also have a Pentair Intellitouch i9+3 control panel. Will the RJ-45 or -60 interface with that system? View answer

Answer posted 6 years ago

Question 33

I have a Hayward Turbo T cell 15. Dead. Controller questionable. Just power and cell cord for controller? Can I just replace cell or do I have to hire a plumber to refit cell? View answer

Answer posted 6 years ago

Question 34

wha tis the difference between rj-60 and rj-60+? View answer

Answer posted 7 years ago

Question 35

With this system will I still have to shock my pool with shocks? View answer

Answer posted 7 years ago

Question 36

I have variable speed pump that has its own controller, so it is powered on all the time. Can I connect the CircuPool system to continous power and let the flow sensor determine when the system should generate chlorine? Otherwise I would need to manually coordinate a timer so that the CircuPool only comes on when the pump is running, and I'd rather not do that. View answer

Answer posted 7 years ago

Question 37

What length of pipe is needed on the return line to accommodate installation of the RJ-60? View answer

Answer posted 7 years ago

Question 38

What is the maximum amp draw of the RJ-60 Plus @ 240V? View answer

Answer posted 7 years ago

Question 39

What is the current draw of the unit at 100% (max current in amps)? I assume it is linear to the output %. View answer

Answer posted 7 years ago

Question 40

Would you install a 220 plug where unit can be plugged into the wall?? View answer

Answer posted 8 years ago

Question 41

I live in Southern California and have a 30k gallon pool with a minor algae problem. Would I be better with the rj-45 plus or rj-60 plus? View answer

Answer posted 8 years ago

Question 42

If I install the RJ-60 unit myself will the warranty still be valid ? View answer

Answer posted 8 years ago

Question 43

Does this unit run on 120 or 240 volts? View answer

Answer posted 9 years ago

Question 44

How long is the power cord on the cell? View answer

Answer posted 9 years ago

CircuPool RJ-60 PLUS Salt Chlorine Generator Q&A

Activity timeframe

View More Product Details

Related Product

Browse by Topic

Tools