My wife purchased the APX P40 to replace the Pentair IC40 we had for 5+ years. If I purchase APX PERFORMANCE P-Series Inner Replacement Cell for the P40 and don't need to use it for a few years, will it work like new when i install or degrade over time. View answer
Asked 6 ´months ago | APX PERFORMANCE P-Series Inner Replacement Cell for the P40 (Housing and Electrode Only)
I have an 8000 gallon pool. I need to replace the salt cell that has failed. The failed cell was a Hayward TCELL940. I believe this salt cell was a little bit of an overkill when installed. What would be a good aftermarket replacement cell. View answer
Asked 1 ´year ago | Salt Cells > APX PERFORMANCE V9 Aftermarket Replacement Cell fits Hayward® AquaRite® T-CELL-9® for 25,000 Gallons Max
I just installed the core 35 and it works great. My pump is on a timer and my generator is plugged in. When the pump turns off the unit shows ""no flow"". Is it ok to just leave it on with the no flow indicator or will cause a problem with my generator ? I have no problem hard wiring it to the timer, do I just cut the plug off and wire to timer ? or is there a separate power cable sold for hard wire to timer ? View answer
Asked 4 ´years ago | CircuPool CORE-35 Salt Chlorine Generator
Does the CORE 35 have a pump timer built in? View answer
Asked 6 ´months ago | CircuPool CORE-35 Salt Chlorine Generator
I've decided to go with the CORE55 unit. The installation video looks pretty simple, but the piping is 2"" and I have 1.5"" pipes and the total span I'll be install the unit into is 14-15 inches. Does the unit come with adapters for 1.5"" pipe and is the span from the filter to the return too short? View answer
Asked 5 ´years ago | Salt Chlorinators > CircuPool CORE-55 Salt Chlorine Generator
Is the ""low salt"" and ""high salt"" determined in the RJ-45 Plus salt generating cell? I have lately have had the controller show ""low salt"" and ""check cell"" and I have carefully cleaned the cell as instructed 3 times in the last 4 weeks View answer
Asked 5 ´years ago | Salt Cells > CircuPool® RJ-45 PLUS Replacement Cell
Have a pool using a Hayward Aqua-rite T-3 is this T-9 a direct replacement? Would like to increase output. I know I will have to reprogram the control unit. Are control units same for all sizes of cells? When I say direct replacement I mean no plumbing, just unscrew old and xxxx on the new plus reprogram of course. View answer
Asked 8 ´years ago | Salt Cells > CircuPool® CIR-GEN9 Aftermarket Replacement Cell fits Hayward® AquaRite® 25,000 Gal. Models
When you say, ""it does not communicate with external controllers"", to operate it, you manually push the buttons correct? I cannot use the Pentair Easytouch remote to operate it. View answer
Asked 3 ´years ago | APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
I bought a CIFCGEN IC40 from you March 1, 2022. It has worked fine. Now, however, the light is on that says ""inspect cell"". The troubleshooting guide says this could mean it needs to be cleaned. I tried that and the light is still on. Do you think it is simply used up. Is there any way to check to see if it has any life left? View answer
Asked 1 ´year ago | APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
