aftermarket salt cells I've found are not compatible with Hayward's ProLogic controller. Can you please confirm that this product is? Do you know of any explanation why ProLogic might have compatibility challenges in general? View answer
Asked 5 ´years ago | Salt Cells > CircuPool® GEN15 Aftermarket Replacement Cell fits Hayward® AquaRite® 40,000 Gal. Models
I have always ran my pump 100% of the time and my pentair ic40 just went out after 7 years. As long as I set the salt generator correctly is it ok if I run my pool pump continuously View answer
Asked 6 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
I have the PPC3 cell in my system now w/13,500 pool. Is the the PPC4 overall height the same as the PPC3 ?I want to buy the PPC4 to run at lower % output to extend the life of the cell from the life I get out of the PPC3. View answer
Asked 4 ´years ago | Salt Cells > Autopilot PPC4 Replacement Salt Cell (for RC-52, SC-60 cells)
My ask Jay 55 circuit pole is leaking. The blue and where the power cord attaches is cracked. The cell works fine but loosing water. This is the second time I have an issue. Before it leaked at the opening where the cord came out. How do I replace the blue end without buying a new cell. Mine is not old and works. View answer
Asked 3 ´years ago | Salt Cells > CircuPool® SJ-55 Classic Replacement Salt Cell
Are the plates in SI-60 cell replaceable? View answer
Asked 4 ´years ago | Salt Cells > CircuPool® Si-60 Replacement Cell
Will this filter work with the Aquarite firmware version 1.4. I currently use a T Cell 15, but some T-15's say they need firmware version 1.5 or newer on the Aquarite. View answer
Asked 2 ´years ago | Salt Cells > Optimum® Simple Cell for T15 Replacement cell fits Hayward® Aqua Rite® T-CELL-15® | up to 40,000 gallons
Running a Goldline control panel with a Hayward T-15 cell. Cell has gone bad. Controls panel is dated 03/2003 and salt cell is dated 2012. Does you cell run on this control panel? View answer
Asked 2 ´years ago | Salt Cells > Optimum® Simple Cell for T15 Replacement cell fits Hayward® Aqua Rite® T-CELL-15® | up to 40,000 gallons
My current IC-40 board in the control panel is partly out (~$240). I do have power to the cell and the lights on the cell are working. However, the salt levels are not being displayed on the control panel. Would this control board need to be repaired to use this salt cell? View answer
Asked 6 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
Do you need to run your pool pump more if you switch to salt View answer
Asked 1 ´year ago
I may need to replace my cell in my SJ-30. If I replace it with the pictured SJ-40 with the blue cap, here is my question. Does the old cell/sensor attach to the cap? Does the old cap pry off? If so, does the new cell attach to the old cap? Thanks for your help. View answer
Asked 7 ´years ago | Salt Cells > CircuPool® SJ-40 Classic Replacement Salt Cell
I currently have a Hayward Aqua plus system 10,000 gallon pool- 10 years old with a t5 cell. I'm getting a low salt reading but salt test strips show a good reading. I believe I have 2 setting options t5 or t3. Can I assume that this would work? I don't seem to find t5 cells that indicate that they will work with Aqua Plus system View answer
Asked 9 ´years ago | Salt Cells > Replacement W3 T-CELL-3 Turbo Cell for Hayward® AquaRite® (AQR3)
