I currently have an eco-smart pool system that uses a cartridge with copper electrodes for algae control and titanium electrodes for bacteria control. The pool has dissolved copper at a rate of 3-5ppm in it. Additionally the chemistry of the water requires 250-400 ppm calcium hardness. If I want to convert will Ihave to do something about the water chemistry? View answer
Asked 3 ´years ago | CircuPool RJ-45 PLUS Salt Chlorine Generator
Does this unit run on 120 or 240 volts? View answer
Asked 9 ´years ago
Is there a way to recalibrate the temperature sensor? My pool waterheater and pool thermometer both indicate that the pool is at 69 degrees F. But the readout on my RJ-60+ shows the water temp. to be around 50 deg F. As a result, the RJ-60+ is not generating any chlorine. It says that the temp. Is too low. Is there anything that I can do to correct the discrepancy in temperature. Charles View answer
Asked 3 ´years ago | CircuPool RJ-45 PLUS Salt Chlorine Generator
So I just got done cleaning my filter, remove the cell and cleaned it as well and added salt to the pool. I feel I put too much in because I’m getting a high salinity alarm. Do I need to drain water out of the pool and put untreated, water back into lower the salinity or will it still chlorinate and just have a high salt contact. View answer
Asked 2 ´years ago | CircuPool RJ-45 PLUS Salt Chlorine Generator
My ask Jay 55 circuit pole is leaking. The blue and where the power cord attaches is cracked. The cell works fine but loosing water. This is the second time I have an issue. Before it leaked at the opening where the cord came out. How do I replace the blue end without buying a new cell. Mine is not old and works. View answer
Asked 2 ´years ago | Salt Cells > CircuPool® SJ-55 Classic Replacement Salt Cell
Is the electric plug round View answer
Asked 1 ´year ago | CircuPool® RJ-30 Replacement Cell
I currently have a Hayward Aqua plus system 10,000 gallon pool- 10 years old with a t5 cell. I'm getting a low salt reading but salt test strips show a good reading. I believe I have 2 setting options t5 or t3. Can I assume that this would work? I don't seem to find t5 cells that indicate that they will work with Aqua Plus system View answer
Asked 8 ´years ago | Salt Cells > Replacement W3 T-CELL-3 Turbo Cell for Hayward® AquaRite® (AQR3)
What's the dimensions of cell, mostly length? View answer
Asked 7 ´years ago | CircuPool® RJ-60 Replacement Cell
I have a older 60k do you have a cell for it View answer
Asked 2 ´years ago | CircuPool® RJ-60 Replacement Cell
Is the power cord included? Also is this unit 220v compatible? View answer
Asked 1 ´month ago
I see in an earlier question, someone asked about the voltage requirements for the unit. I see that the answer was based on 110V or 220V (which I assume is Split phase). My area (north east usa) is primarily 120V -240 V split phase. Is this going to be an issue with your unit? Do i have to cap my Voltage with a transformer? View answer
Asked 5 ´years ago | CircuPool RJ-45 PLUS Salt Chlorine Generator
