I have RJ 20 system (6 years old},cell is over 3 years old. I did have low salt warning with correct salt level in pool, chlorine level was good. Now I have ""no water flow"" warning , Water flow is normal.chlorine production lower My question, do I have problem with cell? or problem with control unit? View answer
Asked 6 ´years ago | Salt Cells > CircuPool RJ20/AG16 Classic Replacement Cell (Electrode Only)
""I have a Mineral Springs- Bioguard T-15 Cell that needs to be replaced, I think? It is 7 years old, and the chemicals seem to be right on, and the reading is 0.It says check minerals and the check cell light is on. What cell do you suggest? "" View answer
Asked 9 ´years ago | Salt Cells > CircuPool® GEN15 Aftermarket Replacement Cell fits Hayward® AquaRite® 40,000 Gal. Models
Is the ""low salt"" and ""high salt"" determined in the RJ-45 Plus salt generating cell? I have lately have had the controller show ""low salt"" and ""check cell"" and I have carefully cleaned the cell as instructed 3 times in the last 4 weeks View answer
Asked 6 ´years ago | Salt Cells > CircuPool® RJ-45 PLUS Replacement Cell
Have a pool using a Hayward Aqua-rite T-3 is this T-9 a direct replacement? Would like to increase output. I know I will have to reprogram the control unit. Are control units same for all sizes of cells? When I say direct replacement I mean no plumbing, just unscrew old and xxxx on the new plus reprogram of course. View answer
Asked 9 ´years ago | Salt Cells > CircuPool® CIR-GEN9 Aftermarket Replacement Cell fits Hayward® AquaRite® 25,000 Gal. Models
I have the SGS 540. Both the cell cap and cell base have hairline cracks and need replacing. Can I order the parts needed for replacement or do I need to replace the entire unit? Thanks! View answer
Asked 4 ´years ago | Salt Cells > Saline Generating Systems SGS Breeze 540 Replacement Salt Cell (now CMP Powerclean Salt Ultra)
I see that the ic20 aftermarket replacement does more. My only worry is that it will run constantly. does the flow switch stop the salt generation when the pump is off? If so, I see no reason for the communication cable anyway. Is there any reason not to replace pentair with aftermarket? View answer
Asked 3 ´years ago | Salt Cells > APX PERFORMANCE P20 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC20® Cells | up to 20,000 gallons
What exactly is the super chlorination mode on the p20 ? And is it necessary at installation if the chlorine level in the pool is already between 1.0 and 4.0 ppm ? View answer
Asked 2 ´years ago | Salt Cells > APX PERFORMANCE P20 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC20® Cells | up to 20,000 gallons
I am considering going salt. I have a pentair system. My pool is just under 20k gals. Would the salt generator for a 60k gal pool be overkill? As my pool seems to grow algae easier and often. I get my pool water checked 2-3 times a week. Almost always I’m low on chlorine. I typically go through 6 bags of shock per week and 5 gals of liquid shock along with chlorine tablets. And my water is very seldom clear. ALL my numbers/levels are within range.. I havnt seen the bottom of my pool in a couple months. My hope is that a salt generator would get things better. View answer
Asked 1 ´year ago | Salt Cells > APX PERFORMANCE P60 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC60® Salt Cells | up to 60,000 gallons
i am replacing a ic30 pentair with ic60 i want to make the purchase very soon but i will not install it till summer time when does the warranty start also i realize i have to cut the pipes to install it because it is larger does the unit come with the other half of the unions and o rings to do the install thank you View answer
Asked 1 ´year ago | Salt Cells > APX PERFORMANCE P60 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC60® Salt Cells | up to 60,000 gallons
