My current IC-40 board in the control panel is partly out (~$240). I do have power to the cell and the lights on the cell are working. However, the salt levels are not being displayed on the control panel. Would this control board need to be repaired to use this salt cell? View answer
Asked 6 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
When you say, "it does not communicate with external controllers", to operate it, you manually push the buttons correct? I cannot use the Pentair Easytouch remote to operate it. View answer
Asked 3 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
I have always ran my pump 100% of the time and my pentair ic40 just went out after 7 years. As long as I set the salt generator correctly is it ok if I run my pool pump continuously View answer
Asked 6 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
I have a Pentair Ichlor IC 30. I asume this unit will work with the same Pentair power center? Just different dimensions for the piping install? View answer
Asked 3 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
Does this pump have Viton shaft seal material? View answer
Asked 1 ´month ago
I currently have a 40,000gal below ground chlorine pool and would like to switch to salt system but I just had to replace my Hayward filter tank. Can I still use the same filter tank with a salt system or would I have to get a new one? View answer
Asked 6 ´years ago | Salt Chlorinators > CircuPool CORE-55 Salt Chlorine Generator
can this system be used on above ground pools? View answer
Asked 7 ´years ago | Salt Chlorinators > CircuPool CORE-55 Salt Chlorine Generator
Will it stink eyes that are open under water? View answer
Asked 3 ´years ago | Salt Chlorinators > CircuPool CORE-35 Salt Chlorine Generator
I bought a CIFCGEN IC40 from you March 1, 2022. It has worked fine. Now, however, the light is on that says ""inspect cell"". The troubleshooting guide says this could mean it needs to be cleaned. I tried that and the light is still on. Do you think it is simply used up. Is there any way to check to see if it has any life left? View answer
Asked 2 ´years ago | Salt Cells > APX PERFORMANCE P40 Aftermarket Replacement Cell fits Pentair® IntelliChlor® IC40® Salt Cells | up to 40,000 gallons
Is the ""low salt"" and ""high salt"" determined in the RJ-45 Plus salt generating cell? I have lately have had the controller show ""low salt"" and ""check cell"" and I have carefully cleaned the cell as instructed 3 times in the last 4 weeks View answer
Asked 6 ´years ago | Salt Cells > CircuPool® RJ-45 PLUS Replacement Cell
How does this system know how much CO2 to add to the water? Does it monitor PH levels and turn on when needed or does it simply inject an adjustable constant flow of CO2. View answer
Asked 3 ´years ago | pH Control > CircuPool TOTALBalance pH Control System with Patented CO2 Infusion | Acid-Free
Asked 5 ´months ago
I'm looking for a replacement for ECOmatic ESC 16, 240V up to 15,000 gal. I note it is out of stock. Will you be getting more replacement items for this system, or is there something else that will work? I was told I have an issue with the control box as well although it is currently still working. What is recommended? If I haven't given you adequate info please tell me what you need? View answer
Asked 3 ´years ago | Salt Cells > APX PERFORMANCE E13 Aftermarket Replacement Cell fits Ecomatic® ESC24 / ESC36 / ESC48 Salt Cell
I have 16.5 inches of pipe above my pump. Is that enough? View answer
Asked 5 ´months ago
Asked 5 ´months ago
