Can the flo switch go in front or behind the salt cell? View answer
Asked 8 ´days ago
Is there a replacement electrode only for the circupool RJ45+ salt cell? View answer
Asked 2 ´months ago
My pump runs 24hrs a day, 4 hours on a high setting and the rest on a low circulation. Will the cell also run 24hrs a day and therefore burn out in around 400 days? Should I put the cell on a timer or just let it run constantly? View answer
Asked 5 ´months ago | Salt Chlorinators > E-CHLOR Plug-In Electronic Chlorine Generator | APX PERFORMANCE | For Pools up to 32,000 Gallons
How many gallons are this system View answer
Asked 5 ´months ago | Salt Chlorinators > CircuPool Universal25 Salt Chlorine Generator
I have had my chlorinator for 2 years. Recently it has been giving a low salt reading and not running. After testing salt (3600), cleaning and calibration of unit. It worked fine for 2 days. Now back to low salt setting and not working. Does the flow sensor need replacement? View answer
Asked 7 ´months ago | Salt Chlorinators > APX PERFORMANCE P40 Complete Salt Chlorine Generator
What is the length of the cell for the 40 unit?Can just the cell be replaced when it reaches the end of its life cycle? Cost?I have a hardwired Pentair IC40. How difficult will it be to switch over wiring to your unit? View answer
Asked 8 ´months ago | Salt Chlorinators > CircuPool EDGE-40 Salt Chlorine Generator
My PVC runs horizontal, and have pipe running parallel, under the section where I need to install this, which doesn’t leave me with enough clearance needed for the bottom of the cell. Can I pivot this when installing so the controls are back at an angle, and the bottom of the cell is more towards the front, to get around the PVC below? Or does this need to be installed straight up and down as shown? View answer
Asked 8 ´months ago | Salt Chlorinators > E-CHLOR Plug-In Electronic Chlorine Generator | APX PERFORMANCE | For Pools up to 32,000 Gallons
What’s the returns policy plz ? View answer
Asked 8 ´months ago | Salt Chlorinators > CircuPool RJ-45 PLUS Salt Chlorine Generator
I have a rectangular pool approximately 17000 gallons and was looking at the sj35 chlorine generator. Would it be advantageous to go with the sj45 since its not a lot more in cost and would that do a better job for my pool. View answer
Asked 8 ´months ago | Salt Chlorinators > CircuPool SJ-45 Salt Chlorine Generator
Does the app have the ability to set up a schedule for the SWG? So that you can snyc it with a programed VS pump schedule. This way the SWG is only on when the pump is running? View answer
Asked 8 ´months ago | Salt Chlorinators > CircuPool CORE-CONTROL55 Automation Platform | Electronic Chlorine Generator | WiFi-Enabled
I have an inground pool that is approximately 17k gallons and would like to know if the SJ35 would be a good choice for a replacement chlorine generator. I currently have a Breeze 320 that is not working and noticed that the SJ35 is similar in appearance and installation. View answer
Asked 8 ´months ago | Salt Chlorinators > CircuPool SJ-35 Salt Chlorine Generator
Can a CS40 be cleaned, and View answer
Asked 9 ´months ago
I have the jacuzzi jss 40 I need to replace. Do you have a direct fit? Also my generator is wired into same circuit as pump but the pump has internal timer so the swg has power all the time.just stops when it detects low flow. Is this an issue? View answer
Asked 9 ´months ago | Salt Chlorinators > CircuPool SJ-45 Salt Chlorine Generator
